Removing Biotel Monitors: A Step-By-Step Guide For Beginners

The BioTel Heart Monitor is a portable device that allows users to monitor their heart health from the comfort of their homes. It offers continuous cardiac monitoring at a reasonable cost and provides dependable and precise data. The monitor can be worn during most activities, including exercising, but must be removed for water-based activities such as swimming. The BioTel monitor comes with a patch that adheres to the skin and must be replaced when the sensor battery is low or if the patch is loose. Before removing the patch, the monitor must be turned off.

Removing the sensor from the patch

To remove the sensor from the patch of your BioTel Heart Monitor, you must first turn off the monitor. This is an important safety precaution to ensure that the device is not actively transmitting data while you are handling it.

Once the monitor is turned off, you can begin the process of removing the sensor. Start by holding the patch with one hand to stabilize it. With your other hand, carefully fold the clear adhesive on top of itself. This step is crucial to ensure that the adhesive does not accidentally stick to other parts of the patch or your skin.

After folding the adhesive, you can begin to gently pull the patch material away from your body. Do this slowly and carefully to avoid any discomfort or skin irritation. Pull the patch away from your skin in the direction of hair growth if possible, as this will minimize the risk of skin irritation.

As you remove the patch, pay attention to the sensor's location. The sensor is a small, discrete component that is connected to the patch. It may be slightly adhered to your skin, so gently lift it away, ensuring that it comes off cleanly and does not detach from the patch.

Once the patch is completely removed from your skin, you can separate the sensor from the patch. This step may vary depending on the model of your BioTel Heart Monitor, but generally, you will need to locate the patch tab. This tab is specifically designed to facilitate the removal of the sensor. Gently pull on the patch tab to detach the sensor from the patch. Ensure that you do not pull too forcefully to avoid damaging the sensor or losing the data stored within.

After removing the sensor, you may need to properly dispose of the patch or prepare it for charging, depending on your specific model and instructions provided by the manufacturer. Remember to handle the sensor with care, as it contains sensitive electronics and critical data recorded during your monitoring period.

When to change the patch

The BioTel Heart Monitor patch should be changed when the sensor battery is low and needs charging, or if the patch becomes loose and requires replacement. The frequency of changing the patch will depend on the duration of your prescription and monitoring period. It is important to keep the adhesive on the back of the patch secure and ensure it is not peeling off.

The BioTel Heart Monitor is a user-friendly, portable device that allows individuals to monitor their heart health remotely. It provides continuous cardiac monitoring and can be worn during daily activities, including exercise, to collect data for accurate diagnosis by a physician. The monitor should be removed when engaging in water activities such as swimming or bathing.

To ensure optimal performance of the patch, it is recommended to place it on a clean, dry area of the skin, avoiding any irritated or broken skin. When applying the patch, remove the film from the back, apply the adhesive side to the skin, press down firmly for approximately 30 seconds, and then remove the backing paper from the front of the patch.

By following these guidelines and changing the patch as needed, users can ensure they are receiving accurate and reliable data from the BioTel Heart Monitor for effective cardiac monitoring.

Placing the patch on the skin

To place the patch on the skin, follow these steps:

Firstly, prepare the skin by shaving, if necessary, then washing and drying the area. Once the skin is dry, scrub the area with a scrub pad for one minute. Do not apply any lotions or oils, as this will cause the stickers to lift.

Next, take a patch from the patch pouch and place the sensor into the patch, pressing down firmly to snap it into place. Locate the Patch Placement Template in the kit and follow its instructions for use. Remove the clear backing and apply the patch to your chest, using the template as a guide. You can use a mirror to help guide you. Once the patch is in place, remove the template and press the patch firmly against your skin, then remove the top white paper.

If you are experiencing discomfort or need to wear the patch for a longer duration, you can apply a new patch by following the same steps.

Removing the monitor while travelling

When travelling with a BioTel heart monitor, there are a few things to keep in mind. Firstly, it is safe to travel with the monitor, and you can even travel with it on your person. However, if you are flying, it is recommended that you remove the monitoring system and pack it in your carry-on luggage. This is likely due to security and safety reasons.

If you are travelling with the monitor, it is important to keep wearing it as much as possible, especially if you are in the middle of a monitoring period. This will ensure that your physician receives a complete set of data for an accurate diagnosis. Of course, you should always follow any specific instructions provided by your doctor.

If you are travelling with a BioTel Heart MCOT Patch, you may need to change it several times during your trip, depending on the duration of your prescription. Make sure to bring extra patches, as well as the necessary tools to remove and replace the patches, such as adhesive wipes and lotion for your skin. To remove the patch, follow these steps:

• Before removing the MCOT Patch, turn off the monitor.
• Hold the patch as shown in the video tutorials available on the website.
• Fold the clear adhesive on top of itself to get it out of the way for the next step.
• Start at one end and gently pull the patch material away from your body to remove it.
• Locate the patch tab.
• Slowly peel the patch away from your skin.
• Wipe your skin and the patch with the provided adhesive removal wipe pad.
• Apply lotion to your skin to remove any remaining adhesive.

Remember to bring a copy of the Patient Diary when travelling, as it contains a Security Screening Statement that can be presented to airport security authorities if needed. You can download a copy from the BioTel website if needed.

Removing the monitor while bathing

It is important to keep your Biotel monitor on at all times, except when bathing or if your doctor has instructed otherwise. Here are some detailed instructions on how to remove your Biotel monitor while bathing:

Before you start, make sure you have everything you need within reach, including a towel and any necessary supplies for cleaning and drying your skin. It is also recommended to have a plastic bag or container to store the monitor temporarily while you are bathing.

First, turn off the monitor. This is an important step to ensure that the device is not accidentally activated while you are bathing.

Next, you will need to remove the adhesive patches that hold the monitor in place. Start by folding the clear adhesive on top of itself to get it out of the way. Then, gently pull the patch material away from your skin, starting at one end and slowly working your way across. Be careful not to pull too hard, as this may cause skin irritation.

Once the patch is removed, clean your skin with warm water and a mild soap to remove any remaining adhesive. You can also use lotion to help dissolve the adhesive and soothe your skin. However, be sure to let the lotion sink into your skin before gently wiping away any remaining residue with a soft cloth or tissue.

After bathing, you can reattach the monitor by following the instructions provided with your specific Biotel device. Make sure to press the adhesive firmly onto your skin to ensure proper contact.

Remember, it is important to keep your Biotel monitor charged and properly adhered to your skin at all times, except when bathing, to ensure continuous and accurate heart monitoring.

Frequently asked questions