Polaroid Camera Battery Replacement: A Step-By-Step Guide

If your Polaroid camera is not turning on, the battery may be dead. Unlike other camera models, the battery in a Polaroid camera is usually housed in the film pack, not in a battery compartment within the camera. To replace the battery, you will need to replace the film pack. This can be done by opening the flash lid to expose the lens, pressing the film door release button, removing the old film cartridge, inserting a new film cartridge, and closing the flash lid. It is important to note that transferring film from a cartridge with a dead battery to a new cartridge with a working battery must be done in complete darkness.

How to Replace Batteries in a Polaroid Camera

How to replace the battery in a Polaroid One 600

The Polaroid OneStep 600 camera does not have a battery compartment. Instead, the battery is housed within the film pack. This means that to replace the battery, you need to replace the film pack. Here is a step-by-step guide on how to do this:

• Open the flash lid to expose the lens.
• Press the film-door release button on the bottom side of the Polaroid. The door will open.
• Remove the old film cartridge. If there is film in the camera, grasp the tab at the front of the film, pull it straight out and then set it aside for disposal.
• Open the bottom compartment of the camera by sliding the lever towards the opening.
• Remove the old film/battery cartridge from the camera.
• Take a new film pack out of its packaging.
• Insert the new film cartridge into the slot, following the instructions that came with the cartridge.
• Close the battery compartment of the camera.
• Raise the film cover. The Polaroid will eject the film-cartridge sheet.
• Pull out the ejected sheet and discard it.
• Close the flash lid.

Your Polaroid OneStep 600 camera should now be powered and ready to use.

How to replace the battery in a Polaroid 600 OneStep Express

The Polaroid 600 OneStep Express camera does not have a separate battery. Instead, the battery is located within the film cartridge. Therefore, to replace the battery, you will need to replace the film cartridge. Here is a step-by-step guide on how to do this:

• Open the flash lid to expose the lens.
• Press the film-door release button on the bottom side of the Polaroid. The door will open.
• Open the bottom compartment of the camera by sliding the lever towards the opening.
• Remove the old film cartridge. Since the battery is dead, dispose of the old film cartridge.
• Insert a new film cartridge into the slot.
• Raise the film cover. The Polaroid will eject the film-cartridge sheet.
• Pull out the ejected sheet and discard it.
• Close the flash lid.

Please note that the Polaroid 600 OneStep series uses Polaroid's 600 Platinum film, and each new film cartridge will contain a fresh battery.

How to replace the battery in a Polaroid 600 camera

The Polaroid 600 camera is a colour instant film camera. Unlike other camera models, its battery is housed in the camera's 10-shot film pack, not in a separate battery compartment. This means that when your camera won't turn on, the film pack's battery is most likely dead, and the pack will need to be replaced.

To replace the battery in your Polaroid 600 camera, start by opening the flash lid to expose the lens. Then, press the film door release button on the bottom side of the camera to open the film door. If there is film in the camera, grasp the tab at the front of the film pack, pull it straight out, and set it aside for disposal.

Next, take a new film pack out of its packaging and slide it into the empty slot. Close the film door. If the camera has been inserted correctly, it should automatically eject the film cover, and the counter will read "10", indicating the number of shots remaining. The battery in the new film pack will now power the camera, and it is ready to be used.

How to replace the battery in a Polaroid film cartridge

To replace the battery in a Polaroid film cartridge, you will need to transfer the film from the old cartridge to a new one. This is because the batteries in Polaroid film cartridges are not replaceable and cannot be purchased anymore.

Firstly, check if the film cartridge's battery is dead. To do this, pull out the cartridge, wait about 10 seconds, and then put it back in. If the camera doesn't make any sounds, the battery is dead.

Next, obtain a new cartridge with a working battery. Finish off this cartridge, but instead of throwing it away, keep it to use again. You can buy new Polaroid film cartridges on their website or on Amazon.

Now, you will need to transfer the film from the old cartridge to the new one. This process must be done in complete darkness, without even a safety light. You will need to slide the film out of the old cartridge and insert it into the new one by pressing down on the metal base as you insert the film through the slot in the front. Repeat this process until all the film has been moved.

Finally, place either an exposed Polaroid or a darkslide on top of the new stack of film. The darkslide is the black piece of cardboard that sits on top of the undeveloped images to protect them from light. When you re-insert the cartridge into the camera, the top sheet of film will be ejected, so it won't be wasted.

How to replace the battery in Polaroid camera models: 330, 420, 430, 440

To replace the battery in Polaroid camera models: 330, 420, 430, 440, you will need a 3 Volt Alkaline Battery. The battery is also known as V24PX, RPX24, A24PX, EPX24, 2LR50, or 1308AP.

First, check that your camera model is compatible with the battery. In addition to the models mentioned above, this battery is compatible with the following Polaroid camera models: 103, 104, 125, 135, 210, 215, 315, 320, M60, and Countdown 70. These models only require one battery to operate.

Next, check the specifications of the battery to ensure it is the correct size. The output voltage should be 3V, with a length of 42.4mm and a diameter of 16.8mm.

Once you have the correct battery, simply replace the old one with the new one, ensuring that it is inserted correctly according to the polarity indicators (+ and -) on the battery.

It is always a good idea to have a few spare batteries on hand, especially if you are planning on taking a lot of photos or will be unable to purchase new ones for a while.

Frequently asked questions